MINERAL INSULATED ELEMENT THERMOCOUPLES

MINERAL INSULATED ELEMENT THERMOCOUPLES

评论

发表评论

此博客中的热门博文

Tolerances on Temperature Reading

图片
1. JIS C1602 – 1995 IEC 584-2-1982 (Amendment 1 – 1989) BS/EN 60584-2-1993 DIN/IEC 584-2-1992 Note: 1. Tolerance denotes the maximum allowable value obtained by subtracting the temperature reading or the temperature at the hot junction from the standard temperature converted from the applicable temperature EMF table. 2. Tolerance Class 1 for Type R and S only apply to the Standard or Refence thermocouple. 3. │t│denotes the value of temperature (°C) irrespective of positive (+) or negative (-) sign. 4. Tolerances listed in this page apply to the new thermocouple wires. • not standardized yet by JIS 2. Tolerance on Temperature Reading To ASTM E 230-1998, E988 – 1996 Note: The above color codes are in accordance with ASTM E 230 – 1998 Contact: thermocouplesupplier@gmail.com
阅读全文

THE DIFFERENCE BETWEEN TYPE K & TYPE J THERMOCOUPLE CHT (CYLINDER HEAD TEMPERATURE) SENDING UNITS?

The primary differences between the two thermocouples are: Measuring Range... Type K = -330°F to +2460°F (-200°C to +1250°C) Type J = -40°F to +1382°F (-40°C to +750°C) Sensitivity... Type K = approximately 41 µV/°C Type J = approximately 55 µV/°C If you already own a gauge it is important that you use the correct thermocouple sensor type, otherwise the result will be incorrect CHT temperature readings due to mismatched sensitivities. Contatc: thermocouplesupplier@gmail.com
阅读全文